宁波环氧地坪漆

With per capita income of the country increases every year, and continuously improve the living environment and the quality of people's life gradually improved, and because of WTO accession, making China's furniture manufacturers now face unprecedented opportunities and challenges in the face of such grim !! the situation and an increasingly competitive market {TodayHot} field, improve their production levels in the mix becomes the only way to stand up. However, in addition to the design and selection of products of wood, but for consumers the most impressive is the first surface coating of the furniture.

 In today's entire Chinese furniture manufacturing, conventional air spray due to lower initial investment cost and relatively simple maintenance management and other factors, most of it is currently being used by the furniture manufacturer. Although the conventional air spray coating to provide good atomization of the manufacturer, but still there are many problems:

 1. The paint transfer efficiency is too low, so-called transfer efficiency refers spray paint used and the actual ratio attached to the surface to be coated paint, in general, conventional air spray transfer efficiency of about 40% or less, in other words, conventional air spray when spraying paint over sixty percent are wasted. Most of these waste paint present in the air, the floor and spray the room.

 2. mist flying too large, because of the need to use 6-8 kg of air pressure when conventional air atomizing spray gun to paint thoroughly, so when spraying mist appears quite serious bounce and scatter paint such {HotTag} Anti-fog spray will not only shorten the maintenance cycle, it will cause environmental pollution.

 3. harm to human health, according to medical clinical trials reported serious scattering operator if long-term place in the mist, then the nose, throat, mouth, respiratory tract, skin and liver have a lot of damage, the United States studies have pointed out, Such scattering of mist and even cause cancer!

 The production rate is low, except for some pressure tank or central system for the paint manufacturers, most of the manufacturers have to use (the pot type) or siphon gravity (pot under the formula) of the main air gun, Such gun in operation frequently need to add paint, caused no continuity of work, so that reduce productivity.

 While conventional air spray gun has a lot of shortcomings, but this invention nearly a century of spray technology is still being the majority of domestic furniture manufacturers are in use with, are in the 21st century, under the professional and technical advances in the case, painted furniture Mounting Technology still marking time in the last century it?

 In fact, in the West, many furniture manufacturers in the United States and Europe are now widespread spraying technique called "mixed gas", as the name suggests, the technology that is based on the principle of airless spray as the basis (the fluid through the column After the plug pumped through a narrow nozzle extruded to achieve atomization), and mixed with a few air molecules in the spray swath spraying coating makes smooth smooth and compact and uniform. Compared with conventional air spray, Airmix application in furniture manufacturing when there are many obvious advantages:

 1. Paint savings of more than 30%, tested, mixed gas spray paint transfer efficiency up to 78% compared with conventional air spray, paint saving rate of 37%, Airmix initial investment costs than conventional air spray high , but the actual return on investment is quite short.

 2. mist bounce low, due to the mixed gas spray without high air pressure will be able to paint completely atomized, it is almost invisible when spraying mist scattering and any rebound, this way, the operator can not only reduce health hazards, and help reduce environmental pollution